Episode 14: Building the Dumas 41′ USCG Utility Boat in 3/8″ = 1 foot scale

Episode 14: Adding the Fore Cabin Sides and Top

Step 36 suggests tack-gluing the lower cabin sides to C4, but since it will be removed later, I ignored this. It will be hard enough to get it out while leaving the top edge glued to the roof without any other glue points to deal with.

Episode 1: The Building Board
Episode 2: Building up the keel
Episode 3: Adding the formers and sheers
Episode 4: Adding the chines
Episode 5: Adding the bottom planks
Episode 6: Removing the hull from the building board
Episode 7: Adding the center deck
Episode 8: Adding the side decks
Episode 9 Adding the side planks
Episode 10: Trimming the side planks
Episode 11: Adding the rear deck
Episode 12: Filling and sanding the hull
Episode 13: Adding the cabin formers
Episode 14: Adding the fore cabin sides and tops
Episode 15: A workaround to a mistake made in Episode 13